Is your garage door grinding, squealing or shuddering? We handle garage door roller replacement throughout Tucson, Oro Valley, Marana, Vail, Sahuarita and Rita Ranch. Most sectional doors ride on ten rollers, and out here their bearings fill with fine dust long before they wear out. Tired rollers sit behind most of the noise complaints we hear, and they are the usual reason a door jumps its track. Our tune-up with roller replacement included runs about $120.
Full roller set in a $120 tune-up
Quiet sealed nylon rollers
Usually done in one visit
5.0On Google reviews
ROC #322606Arizona license, bonded and insured
Angie’s List2019 Super Service Award recipient
1,500+Homes served since 1999
Schedule your roller swap
Rollers in a ~$120 visitPriced onsiteInbox stays clean
Grinding or squealing? Phone (520) 579-9084 · New rollers in a $120 tune-up · Most roller jobs take one trip
Rollers and parts
Rollers for any make
Sound familiar?
Rollers give more warning than almost any other part. That warning is the cheap window in which to act.
01
The classic sign. The bearing has lost its grease, taken on dust, and is now rolling metal on grit. Once you can hear it from inside the house it has been going on a while.
02
A roller with a flat spot does not roll, it skids. You feel it as a stutter at the same point in the travel every time.
03
That is the roller wearing itself away. Worth looking for, because it confirms the diagnosis without taking anything apart.
04
A bent stem or a wheel that no longer turns. This is the stage immediately before the door starts trying to leave the track.
Price my roller job
Tell us what you hear, a grind, squeal or shudder, plus roughly how old the door is. Want to talk instead? Ring (520) 579-9084 and you reach a real person, day or night.
Roller help by phone
Inside the visit
Straightforward work, and normally one appointment, from first listen to a door you can hear the difference in.
01
Where the noise happens in the travel tells us whether it is rollers, bearings, hinges or the opener.
One trip, most doors
02
You are shown the worn rollers, and given the number for the set before anything is fitted.
Set price, shown first
03
The full set changed, hinges checked, rollers lubricated, track wiped clean, and the door cycled so you can hear the difference.
Door balance checked
When rollers go too far
What your rollers cost
New roller set and tune-up
roughly$120
New rollers part of the visit
Few garage door fixes cost this little or change this much. A full set of new rollers is part of our roughly $120 tune-up, and four factors shift your total.
01
Most sectional doors take ten. Taller doors and some double doors take more.
02
Sealed nylon costs a little more than basic steel and is quieter and kinder to the track. On a door next to living space it is worth it.
03
If hinge barrels are worn oval, new rollers alone will not fix the noise, and the hinges need replacing too.
04
Rollers left to fail completely tend to take a section of rail with them, and that is a different job.
Before a single roller goes on, you see the price for the whole set. If yours still have miles left, we say so, and you approve every part first.
Life in the dust
Each roller carries roughly a tenth of a door that can weigh three hundred pounds, and turns thousands of times a year in an environment full of the finest abrasive dust in the country. That is why they are the first thing to go here and why replacing them is so often the whole fix. A noisy door with good rollers is unusual. A quiet door with bad ones is almost unheard of.
Who fixes your rollers
27+
Years on Tucson doors
1,500+
Households served
ROC #322606
Insured, bonded, AZ licensed
Same day
Most roller jobs, one trip
Job photos


Areas we cover
Roller swap FAQs
More on rollers? Ring us at (520) 579-9084
Our maintenance and tune-up runs about $120 with roller replacement included, and that visit also covers lubrication, spring tension, door balance and the opener. Taller doors, worn hinges or track damage can change that, and the quote comes before anyone picks up a wrench. Every rate is posted on the garage door prices list.
Rollers are rated in cycles like springs, so it depends on use. In Tucson dust usually decides the outcome before the cycle count does, and we see sets that are worn out well before their rated life.
Noticeably, yes, especially when a bedroom or den shares a wall with the garage. Sealed nylon rollers also shield the bearing from desert dust, a bigger deal in Tucson than most places.
You can, but it rarely holds. The others are the same age with the same wear, and the new ones end up carrying the door while the old ones drag.
Not immediately, but it is the early stage of the sequence that ends with a door off its track. Noise is the cheap moment to act.
Use a light lithium or silicone spray made for garage doors, on the roller bearings only. Leave the track dry. Heavy grease grabs Tucson dust and turns into a gritty paste that grinds rollers down.
A typical sectional door runs ten rollers. Taller doors and some double doors take more. We replace the full set, because a new roller next to a worn one simply hands the load straight back to the old ones.
Often. Worn rollers are the most common cause of a door coming off its track. Stop using the door and call (520) 579-9084. If the rail is bent, see our track repair and alignment service.
Yes. We install Amarr, Clopay, Martin and Wayne Dalton, yet we fit rollers on any make, Overhead and older Sears models included. Every roller is matched to your door’s stem length and diameter.
Yes. Your roller job carries our warranty on parts and labor alike. Our Arizona Registrar of Contractors license is ROC #322606, and we carry bonding and insurance.
Swap out a grinding roller set and get the door balance-tested in one tune-up, for roughly $120. A Tucson family business since 1999, Arizona ROC #322606.
